全部

1·The?circuit elements were arranged in a 'ladder circuit' comprising repeating units of thermal resistors and thermal capacitors.

电路元器件包括热电阻和热电容组成的重复单元被安置成为一个梯形电路。

2·Owing to the peculiarities of the PLC Ladder Logic graphic, there may well be the possibilities of the invalidation in the electric chain lock on the circuit.

由于该系列PL C解算梯形图流程的特殊性，容易引起控制电路中电气联锁环节的失效。

3·If we introduce the ladder-shaped circuit simple in good time, the oscillating frequency and oscillating condition of rc phase shift oscillating can be w.

如果能适时地引入梯形电路的简单介绍，则rc移相式振荡电路的振荡频率及振荡条件可以容易地求出。

4·If we introduce the ladder-shaped circuit simple in good time, the oscillating frequency and oscillating condition of rc phase shift oscillating can be worked out easily.

如果能适时地引入梯形电路的简单介绍，则rc移相式振荡电路的振荡频率及振荡条件可以容易地求出。

5·Combination of ladder approach method and equivalent circuit model of slot antenna had been used to analyze its input impedance. Finally, GTD had been used to calculate the radiation pattern.

利用阶梯近似方法结合缝隙天线电路模型分析其输入阻抗，最后采用GTD方法计算该种天线的辐射方向图。

6·Matching characteristics of single staggered ladder slow wave circuit are calculated by eguavelent circuit method in the paper.

文中采用等效电路法计算了单交叉梯形慢波电路的匹配特性。计算结果与实验测量基本一致。

7·This circuit has low element change sensitivity within its LC ladder filter.

该电路具有LC梯形的通带内元件变化的低灵敏度特性。

8·The circuit has adopted the 10bit dual resistor ladder D/A converter and has advantages of high voltage accuracy, simple circuit structure and low power consumption.

采用了10位双电阻梯数模转换电路， 具有输出电压精度高， 电路结构简单， 功耗低等特点。

9·This paper introduces a circuit setting up and displaying the data of timer, counter and data register out of PLC. It gives the ladder-type Patterned program.

介绍了一种对定时器、计数器、数据寄存器的数据进行外部设定并显示的电路，并给出了相应的梯形图程序。

10·A regular NMOS-only M-2M ladder and a current-to-voltage conversion circuit proposed in this paper are adopted in this design.

设计中，采用了一种规则的全NMOS管构成的M-2M梯形电路，以及本文提出的电流-电压转换电路。