全部

1·No. 1 main generator engine fresh water cooling outlet to turbine inlet damaged, to be renewed.

从1号发电机淡水冷却出口到涡轮机进口这一段淡水冷却管损坏，需换新。

2·This paper calculates the temperature of inlet air, and analyzes precedence of gas turbine inlet air-cooling by water spray evaporative cooling in Xinjiang area.

对进气空气的温度进行分析计算，并通过计算的结果分析在我国新疆地区燃气轮机采用喷雾蒸发冷却方式冷却进气空气的优越性。

3·For ship yard, cooling side no water pumps, ductwork, inlet filters, vlves, electrical equipment and savings are need, less installation cost, Fot the owner, less maintenance.

对船厂来说，冷却水侧不需要泵、水管、滤器、阀和电控设备等，安装制造费用低；

4·It is an adiabatic, humidification, and cooling process for gas turbine inlet air by water spray evaporative cooling.

对燃气轮机的进气采用喷雾蒸发冷却的方式降温是一个绝热加湿冷却过程。

5·Increasing overall flow velocity and depressing the inlet temperature of cooling water has little effect on improving temperature distribution.

提高冷却水的总流速和降低进口温度对电池内温度分布的改善作用不好。

6·Reducing the inlet temperature of cooling water and increasing its mass flow are favorable to increase refrigerant performance coefficient, and can decrease optimal pressure at high pressure side.

降低冷却水进口温度和提高其质量流量不仅有利于提高制冷性能系数，而且能降低最佳高压侧压力。

7·The effects of the cooling water and freezing water inlet temperature are also predicted. The results are reasonable.

对地下水源热泵机组的性能随着冷却水、 冷冻水入口水温的变化情况做了预测，结果合理。

8·Cooling towers' influence on the inlet temperature of circulating water was also considered to determine optimum running mode of circulating water pumps.

同时考虑闭式循环水系统中冷却塔对循环水入口温度的影响，确定出循环水泵最优运行方式。

9·The distinctive feeding inlet with consummate water-cooling unit design.

独特的入料口设计，具有完美的水冷装置。

10·The top of the mixing crock is provided with an inlet of sugar materials, a gas entrance, and a pressure gauge, and the outer wall of the mixing crock is provided with a water cooling jacket.

搅拌缸顶部设有糖料入口，气体进出口和压力表，搅拌缸外壁设有冷却水套。