全部

1·You can use a clamping circuit instead of a Schmitt trigger to clean up…

可以使用箝位电路替代Schmitt触发器净化高频输入脉冲。正反馈放大器是信号级脉冲…

2·The threshold detector is similar to a Schmitt Trigger in that it is a latch circuit with a large dead zone.

阈值检测器就是一种回差范围较大的锁存电路，与施密特触发器相似。

3·U1B is a Schmitt trigger that compares the battery voltage to the same stable reference of the other section, but for another purpose: it controls the load switch Q3.

U 1 B的是一个施密特触发器，电池电压比较稳定的其他部分相同的参考，但另一个目的：它控制的负荷开关q3。

4·The A1210-A1214 Hall-effect latches include the following on a single silicon chip: voltage regulator, Hall-voltage generator, small-signal amplifier, Schmitt trigger, and NMOS output transistor.

在A1210 - A 1214霍尔效应锁存包括一个单一的硅芯片上以下内容：稳压器，霍尔电压发生器，小信号放大器，施密特触发器和NMOS输出晶体管。

5·Removing high frequency noise pulses by a low-pass filter and Schmitt-trigger.

用一低通滤波器和施密特触发器排除高频噪声脉冲。