全部

1·After such do well, sole USES thick rope made of hemp close-grained offer emerges, change not to move it with the hand.

这样弄好以后，鞋底用粗麻绳密密实实地纳出来，用手都变不动它。

2·Besides, the parameter used to describe concrete protective coatings increasing materials close-grained capability is fixed on.

还确定了表征混凝土保护涂层提高材料密实能力的模型参数。

3·The pump casing, impeller, motor housing and stationary base elbow shall be manufactured of close-grained cast iron, ASTM A48, Class 30.

泵壳，叶轮，电机壳和固定底座弯头都应该采用符合美国材料试验协会ASTM A48级别30致密铸铁制造。

4·The fill back of the bridge and culvert, because of its especial position, has compressed not very close-grained sometimes. The sinking is a familiar disease.

桥涵台背回填，由于其位置特殊，往往辗压不实，发生沉降是一种常见病害。

5·The submersible motor enclosure including frame, end brackets, flanges and cap assembly shall be constructed of close-grained cast iron, ASTM A-48, Class 30 or better.

潜水电机壳体，包括机架，尾轴承架，法兰和罩盖总装，必须采用符合美国材料试验协会ASTM A - 48类别30标准的、密实的铸铁或更好的材料制造。

6·Pumice concrete after being close-grained and molding is not sensitive to maintaining conditions, and this idiosyncrasy can predigest maintaining measures and reduce lacuna.

浮石混凝土在密实成型后，其凝结硬化过程中对于湿养护的敏感性较小，这有利于简化施工养护措施和减少早期混凝土缺陷的产生。

7·HONIC 400 is not only recommended for cylinder honing on hard, soft and close-grained cast iron but also for flat honing and lapping operations on gauge blocks and gudgeon pins.

雄力400不但推荐于硬质及软质铸铁的汽缸内径搪磨，还适用于块规的平面精磨及轴头销的研光工序。

8·Advantages: it can destroy the ingot casting, steel grain refinement, and eliminating the defect in microstructure, thus making steel tissue close-grained, with improved mechanical properties.

优点：可以破坏钢锭的铸造组织，细化钢材的晶粒，并消除显微组织的缺陷，从而使钢材组织密实，力学性能得到改善。

9·This is the group that Mr Abhisit probably had in mind when he urged Thais to pay close attention to the Supreme Court's fine-grained verdict, which took more than six hours to read aloud.

这些人被阿皮实记在了心里。最高法庭的精密审判需要6个多小时才能大声地读完，阿皮实催促泰国人密切注意这项审判。

密实的

1·The submersible motor enclosure including frame, end brackets, flanges and cap assembly shall be constructed of close-grained cast iron, ASTM A-48, Class 30 or better.

潜水电机壳体，包括机架，尾轴承架，法兰和罩盖总装，必须采用符合美国材料试验协会ASTM A - 48类别30标准的、密实的铸铁或更好的材料制造。

2·Pumice concrete after being close-grained and molding is not sensitive to maintaining conditions, and this idiosyncrasy can predigest maintaining measures and reduce lacuna.

浮石混凝土在密实成型后，其凝结硬化过程中对于湿养护的敏感性较小，这有利于简化施工养护措施和减少早期混凝土缺陷的产生。

3·Besides, the parameter used to describe concrete protective coatings increasing materials close-grained capability is fixed on.

还确定了表征混凝土保护涂层提高材料密实能力的模型参数。

4·Advantages: it can destroy the ingot casting, steel grain refinement, and eliminating the defect in microstructure, thus making steel tissue close-grained, with improved mechanical properties.

优点：可以破坏钢锭的铸造组织，细化钢材的晶粒，并消除显微组织的缺陷，从而使钢材组织密实，力学性能得到改善。