全部

1·Mating portions on the frame and tank (140) guide engagement of a tank outlet with a pump inlet tube.

框架和贮罐(140)上的配合部分导引贮罐出口与泵入口管接合。

2·The sides of the oxygen enriched membrane device are all sealed except top, the bottom and the joint of the air inlet tube.

富氧化膜装置除其上面和底部与进气软管连接处外，其余各面均密封。

3·The analysis of leakage causes for flash trough was presented, and the wear layers on inlet tube and the baffle wear plate inside of flash trough were used to increase the wear life of flash trough.

分析了闪蒸槽泄漏的原因，采用在进口接管堆焊耐磨层及筒体上增加耐磨挡板的方法对闪蒸槽进行了改造，增加了闪蒸槽的寿命。

4·When a cylinder with this valve configuration is in the upright position, the inlet of the tube is immersed in liquid and the liquid phase will be removed.

当带有这种阀门配置的钢瓶处在垂直位置时，管子的入口浸在液体中，就可以提取液相产品。

5·The focal points of designing cyclone separator were involved in cylinder length, dimension of inlet and outlet pipe, cone and filling tube.

简体的长度、进气管和排气管的尺寸以及锥体和下料管是设计旋风分离器时要考虑的重点。

6·The article focuses on two ways to determine friction factors of the capliliary tube without backheating which inlet refrigerant is subcooling liquid.

本文针对无回热且进口处制冷剂为过冷液体的节流管介绍确定其沿程阻力系数的两种方法。

7·Amplitude and phase of pressure fluctuation at the inlet of draft tube as well as the inner flow in draft tube are analyzed in detail.

详细分析了尾水管进口截面的压力脉动的幅值和相位，并对尾水管内的流动做了分析。

8·One of the major measures to suppress flow instability in a boiling tube consists in increasing the flow resistance at the boiling tube inlet section.

增加沸腾管入口段流动阻力是抑制沸腾管内流动不稳定性的主要措施之一。

9·When the inlet diameter is greater than pump inlet should be installed eccentric adjustable tube.

当进水管直径大于水泵进水口时，应安装偏心变径管。

10·Finally, falling film absorption changes with the solution parameters at inlet and system pressure and the change trend is very similar to what happened in the static tube.

最后，改变溶液入口参数及吸收压力，相应的吸收情况有所改变，其趋势与静止状态下的降膜吸收非常一致。