全部

1·The technological procedure of cold drawing was introduced.

对冷拉伸实施步骤进行了介绍。

2·The microstructure evolution and properties transform of 70 steel wires in cold drawing were studied.

研究了冷拉70钢的组织演变和性能变化。

3·An analysis is made with the reliability design of the main link-plate of LB-20 mono-chain pipe cold drawing mill.

对LB - 20单链冷拔管机的主链条链板进行了可靠性设计分析。

4·The article denotes the modification on the heating furnace prior to pointing on seamless steel pipe end for cold drawing.

本文简述了无缝钢管冷拔前头部加热炉的改造。

5·Effects of cold drawing and water quench process on mechanical properties of prestressed wires have been studied in laboratory.

在实验室条件下研究了冷拔与水淬火工艺对予应力钢丝力学性能的影响。

6·Effects of cold drawing and water quench process on mechanical properties of prestressed wires have been studied in laboratory.

研究表明碳素钢予应力钢丝采用水淬火取代铅浴进行索氏体化处理是可行的。

7·The microstructure and defects related with hot-rolling and cold drawing of high carbon steel rod were introduced in this paper.

介绍了高碳钢盘条的显微组织及其常见的与热轧工艺、冷拉拔工艺等生产过程相关的组织缺陷。

8·Material in Condition a may be given a final cold drawing for size control or finish, or both, slightly raising tensile strength.

条件A的材料可以通过冷拔来控制大小尺寸和表面质量，或两者。可稍微提高抗拉强度。

9·P There shall be no welds in wires and bars. Individual wires of strands may contain staggered welds made only before cold drawing.

在线材与棒材内部不能有焊接。钢绞线内的单条钢绞线可能有交错焊缝，但必须是在冷拉之前。

10·Diffusion bonding results indicate that the interface situation is different merely by a cold drawing and then a diffusing process.

研究结果表明，冷变形后不同温度下扩散处理的复合界面状况存在差异。