全部

1·The axial load ratio lower than 0.3 has a good benefit on the shear performance of SCC joint;

轴压比小于0.3时，轴压比对自密实混凝土节点起有利作用；

2·The effects of axial restraint, rotational restraint and load ratio of the beam are discussed.

进一步分析了梁的轴向约束、梁端转动约束以及荷载比对约束钢梁受力性能的影响。

3·Taking the capacity to load ratio as the constraint condition, the load scale of substation is resolved.

用变电站的容载比作为约束条件决定变电站的负荷规模。

4·The results show that increasing the boundary confinement ratio of the walls can raise allowable axial load ratio.

研究结果表明，适当增加约束区约束钢筋的配筋率可以提高剪力墙的轴压比限值。

5·Particula emphasis has been devoted to the influence of load ratio and microstructure on behaviour of near-threshold fatigue crack growth.

着重分析了载荷比和显微结构对门坎值附近裂纹扩展行为的影响。

6·The results show that the length of adjusted lines is directly affected by load ratio and non-equilibrium factors within segments of the original lines.

结果证明调整后线路的长度直接受到原线路满载率和断面不均衡系数的影响。

7·For this status, this paper proposes a new load ratio deflection method for making monthly trade schedule of directly dispatched thermal power generation units.

针对此现状，提出了一种负荷率偏差法，用于解决直调火力发电单元月度电能交易计划编制问题。

8·This paper analyses the principal and subordinate relationship between groundwater pollution indexes by using pollution load ratio and gray relation analysis method.

运用污染负荷比和灰关联法递阶分析了矿山地下水污染物的主从关系，确定了矿山地下水的主要污染指标；

9·From the analysis of the experiment results, it is indicated that the axial load ratio on behaviors of CFST subjected to compression-bending loads is the most significant effect factor.

对试验结果进行的分析表明，轴压比对钢管混凝土弯压构件受力性能的影响最为显著。

10·The comparison result of computation value and measure value shows that their deviation is within 3% for low load ratio, and has increasing tendency for high load ratio, but it is within 5%.

对于较小的负荷变化率，压力计算值与测量值偏差小于3%，而较大的负荷变化率时，偏差有增大趋势，但其误差小于5%。