全部

1·The groove depth is bit bigger than the size of the coil section height.

槽深略大于线圈截面高度尺寸。

2·Available groove depth depends on the maximum groove width of the attached insert.

根据可装载刀片的最大槽宽来确定可以加工的槽深。

3·The efficiency of phase grating is limited by groove depth, material, duty ratio and wavelength.

衍射效率受光栅材料、凹槽厚度、占空比和所使用波长的影响。

4·The effects of different machining parameters and structure parameters to fin height and groove depth are analyzed.

分析了不同加工参数和刀具结构参数对沟槽翅高和槽深度的影响。

5·And the influences of such structural parameters as the groove depth and the Angle of the spiral line are also notable.

开槽深度和螺旋角等结构参数对密封性能也有重要影响。

6·To improve sensitivity, a grooved light-incident region is considered and the selection of the groove depth is discussed.

为提高灵敏度，考虑了槽状的光入射区，阐述了槽深的选取原则。

7·The groove depth of the warping roll is as long as a half of the cord diameter. The nip between the pressure roll and No.

整经辊的沟槽深度等于帘线直径，压力辊的沟槽深度为帘线直径的一半。

8·A new method of high accuracy to measure the groove depth of rectangular relief gratings by laser diffraction is proposed.

提出一种浮雕矩形光栅刻槽深度的高精度衍射测量方法。

9·The results show:the groove depth is more important for diffraction efficiency than the duty cycle, which is useful for fabrication of the BSG.

这些都为取样光栅的实际制作提供了有意义的结果。

10·The method is qualified for measurement of groove depth and duty cycle simultaneously for the rectangle-shaped or similar profile of holographic grating mask.

对于要求同时检测矩形或接近矩形槽形的全息光刻胶光栅掩模的槽深和占宽比，该方法完全适用。