全部

1·The working principle and system composition of shock wave soot blower were recommended briefly.

简要介绍了激波吹灰器的工作原理和系统组成。

2·The soot blowing principle, technical parameters and erection method of ws-10 type acoustic soot blower are recommended.

介绍了WS - 1 0型声波吹灰器的吹灰原理、技术参数及安装方法。

3·Bend deformation often occurs on the blowing tube of the soot bl ow er during the test run, and directly affects the regular operation of the soot blower.

在试运转时，吹灰器的吹灰管常常发生弯曲变形，直接影响吹灰器的正常运行。

4·Improvement of PLC control system on new steam soot-blower in heat pipe preheater is introduced.

介绍了可编程控制器在新型蒸汽巡扫吹灰装置中的应用与改进。

5·Application of PLC C200H on new steam soot-blower in heat pipe pre-heater is introduced.

介绍了可编程控制器c 200h在热管空气预热器新型蒸汽巡扫吹灰系统中的应用情况。

6·A new type of steam soot-blower applied on heat pipe preheater is introduced, including its working principle and features.

介绍了新型蒸汽巡扫吹灰器的工作原理、特点和应用情况。

7·The main reasons to the rotary air pre-heater secondary combustion are related to unstable oil gun combustion, internal oil leakage and insufficient soot-blower steam pressure, etc.

锅炉回转式空气预热器发生二次燃烧的主要原因与油枪燃烧不稳定、内部有漏油和吹灰蒸汽压力不够等相关。

8·Valve is the main part for controlling blowing medium, it is at the rear of soot-blower.

吹灰器的阀门是控制吹灰介质进入吹灰枪的咽喉，它位于吹灰器的尾部。

9·Travel switch and its wiring system: When carriage drives the lance tube moving, the travel of Soot-blower is controlled by travel switch.

行程及走线机构：跑车带动吹灰枪运动时，由行程开关控制吹灰器行程。

10·Put the center of the sealing seat and the hole in the wall in a line and according to Figure 3 select method a orb to support the rear of soot-blower.

将吹灰器平置，密封支座中心对准炉墙开孔，根据图三的吊装示意图，选择方法a或方法b支承吹灰器尾部。