全部

1·And gain, common mode rejection ration in folded cascade amplifier.

折叠共源共栅放大器的增益、共模抑制比等。

2·This paper deals with theoretical and practical problems concerning the design of the common mode rejection performance in the isolated computer-controlled multichannel ECG systems.

本文讨论计算机控制的多导心电隔离测量系统共模抑制性能设计的理论和实际问题。

3·A measurement amplifier circuit is designed, which consists of circuits of differential amplifier, a common-mode rejection, double-end and single-end conversions and programmed gain amplifier.

设计了一个测量放大器电路，它由差动放大电路、共模抑制电路、双端单端转换电路和程控增益放大电路组成。

4·The electronic processing system is a common-mode rejection system so that insensitive to intensity fluctuations of the light source and minimizes noise from electronic system.

与接触模式工作的原子力显微镜相比扩大了测量范围。 电子处理共模抑制系统可有效地抑制光强波动和降低系统电子噪声。

5·To maintain outstanding accuracy, even when monitoring motor and solenoid current, the LT1999 guarantees more than 80db of common-mode rejection at 100khz.

为了在监视电动机和螺线管电流时也能获得卓越的准确度，LT1999在100khz时保证具有超过80db的共模抑制。

6·It is not necessary that AMPLIFIERs maintain common-mode rejection for signals beyond the supply voltages: what is required is that they do not self-destruct for momentary overvoltage conditions.

而信号远离电源电压后，再维持放大器的共模抑制是不必要的，需要的却是不为瞬间过电压所毁坏的条件。

7·In this situation, the CMRR (common-mode rejection ratio) of the input differential amplifier was unsatisfactory.

在这种情况下，输入差分放大器的CMRR 不令人满意。

8·The MCU replaces the operational amplifier circuit so as to strengthen the system of common-mode rejection, improve the problems of weak signal transmission.

更换了运算放大调理电路增强了系统的共模抑制能力，改善微弱信号传输中的问题；

9·The main design work as follow: the former disposal circuits were designed, and the circuit possesses very high input resistance, common-mode rejection and voltage gain;

具体设计内容包括：设计具有输入阻抗大、高增益和高共模抑制比的脑电信号调理电路；