全部

1·Refer to Drive Pinion Bearing Pre-Load Adjustment.

参阅驱动小齿轮轴承预荷调整。

2·Remove the depth shims from rear pinion bearing cup bore in axle housinRecord the thickness of the depth shims.

从轴管里的后小齿轮轴承盖孔拆卸限深垫片。 记录限深垫片厚度。

3·If an oil slinger is used behind the inner pinion bearing cone, deduct the thickness of the slinger from the dial indicator reading and use that total for shim selection.

如果抛油环用在内侧驱动小齿轮内圈的后面，从针盘指示表读数中扣除抛油环的厚度，垫片的选择用这个总数。

4·This article, on the basis of studying the structure of pinion gear assembly and pinion bearing pre-load mechanism, analyses the main factors which have impact on pinion bearing preload.

文章在研究主齿总成结构及主齿轴承预紧原理的基础上，深入分析了影响主齿轴承预紧的主要因素及其影响机理；

5·Install pinion front bearing, if necessary.

如需要，安装小齿轮前轴承。

6·The pinion shaft runs in porous bronze bearing bushes.

小齿轮轴运行多孔青铜轴承衬套。

7·The requirement of producing high quality carbon construction steel, pinion steel, bearing steel, low-alloyed high tensile steel, low-alloyed hardened and tempe…

能满足转炉生产优质碳素结构钢、齿轮钢、 轴承钢、 低合金高强度钢、低合金调质钢、 非调质钢等钢种的需要。

8·Rotate the pinion gear several complete revolutions to align the bearing rollers.

转动主动齿轮若干圈以校正轴承滚柱。

9·Double bearing Clutch Bell Pinion Pinion gear is now dual ball bearing supported.

前翼齿轮现在是双滚珠轴承承托的。