全部

1·The EPDM was vulcanized by reaction extrusion moulding.

采用反应挤出法对EPDM进行动态硫化。

2·The ceramics core was prepared by extrusion moulding applied in the titanium alloy golf club head.

利用挤压成型的方法，制备了应用于钛合金高尔夫球杆头精密铸件的陶瓷型芯。

3·This paper introduces the production technology of the injection and extrusion moulding of Nylon 11.

介绍尼龙11的注射成型和挤出成型工艺，并讨论了生产中易出现的问题及其解决办法。

4·The raw materials, extrusion pressure, pressure holding time and molding temperature during extrusion moulding have great effects on the quality of products.

挤压成型过程中原材料、挤压力、保压时间和成型温度对制品的品质影响较大。

5·Moreover, PS theological phenomenon is analyzed and the basic method for determining the extrusion moulding conditions of PS fluorescent lamp-shade is developed.

并分析PS流变现象，提出确定PS日光灯罩挤出成型工艺条件的基本方法。

6·The new extrusion equipment has been designed to research the rheological behavior of LLDPE extrusion moulding in complex stress filed of vibration and shearing.

利用振动剪切挤出装置研究了线性低密度聚乙烯(LLDPE)在振动与旋转剪切复合力场中挤出成型时的流变行为。

7·It has been found that the new elemental composition in extrusion moulding is epoxy and paraffin. and the precision zirconia ceramic ferrules have been obtained.

获得了环氧树脂和石蜡两种新的二氧化锆成型配方。

8·Out of many ceramic fabrication techniques, extrusion moulding is considered to be the most suitable method for producing a variety of shapes with constant cross-section.

挤出成型在各种陶瓷成型工艺中被认为是最合适生产等截面制品的低成本工艺。

9·This paper introduces the production technology of the injection and extrusion moulding of Nylon 11. The problems emerged in the production and their solving methods are discussed.

介绍尼龙11的注射成型和挤出成型工艺，并讨论了生产中易出现的问题及其解决办法。

10·To control the melt flowing and foaming of polymer are the key factors to ensure the quality of products during the extrusion moulding of the integral door leaf of low foamed rigid PVC.

在低发泡硬质聚氯乙烯整体门板的挤出成型中，控制聚合物熔体的流动和发泡是保证产品质量的关键。