全部

1·They are oriented along the ?ow, and the degree of their alignment is highly dependent on the rate of deformation.

它们的方向是根据流向而定的，而且其形成线性的程度高度依赖于变形率。

2·The least square method is applied to study the deformation tendency and calculate the mean annual rate of deformation.

用最小二乘法拟合了库区地壳形变多年的变化趋势，计算了多年平均形变速率。

3·Its transient recovery rate of deformation, complete recovery time of deformation and maximal compressive strength were determined with biomechanical approach.

用生物力学测定仪测定其不同压缩比率下的瞬时形变恢复率、最大形变恢复率及最大极限压缩强度。

4·A repeated period of measurement across the fault is mainly determined by observation accuracy and rate of deformation. It is the best period for they to match reasonably.

跨断层测量的复测周期主要由观测精度和断层位移速度决定，二者合理匹配的周期就是最佳周期。

5·The analysis result shows that bearing capacity of composite foundation determined by relatively deformation and change rate of deformation is more suitable for composite foundation.

对复合地基承载力的取值标准进行了分析，分析表明采用相对变形值和变形值变化率确定承载力取值更符合复合地基的情况。

6·Strong earthquakes occurred in the high-value region and its margins of shear strain rate, especially in the high-value region of shear strain rate in accordance with tectonic deformation background.

强震通常发生在剪切应变率的高值区及其边缘，尤其是与构造变形背景相一致的剪应变率高值区。

7·With the decreases of deformation temperature and increases of deformation degree and deformation rate, the recrystallized grain size decreases and the recrystallization volume percent increases.

随着变形温度的降低、变形程度和变形速率的增大，再结晶晶粒尺寸减小，再结晶体积分数增大。

8·The effect of carbon, molybdenum and rare earths on hot cracking susceptibility of austenitic stainless steel welds was studied with continuously variable deformation rate cracking test (VDR) method.

应用变形速率连续可变式热裂纹试验方法(VDR法)研究了碳、钼和稀土元素对奥氏体不锈钢焊缝热裂敏感性的影响。

9·Finally, the relation among component of shear deformation, component of extension deformation and deformation rate and tectonic earthquake is analyzed on the basis of a example.

最后根据实例计算结果分析了剪切变形分量、扩张变形分量与形变速率、构造地震的关系。

10·The influences of deformation temperature, deformation rate and deformation degree on the flow stress and grain size are different. The deformation degree mainly influences the shape of flow curves.

结果表明：变形温度、变形速率和变形程度对流动应力和再结晶晶粒尺寸均有不同程度的影响。