全部

1·The paper introduced the working principle of the lead hardening temperature measuring and control system for the steel wire base on the fuzzy suitable PID control.

阐述了基于模糊自适应PID控制的钢丝绳用钢丝铅浴淬火温度测控系统的工作原理。

2·Using infrared system the apparatus of non-touching at limited-area to monitor the hardening temperature at site is produced for high-frequency induction heat treatment.

利用红外测温原理，研制出高频热处理时的小目标非接触式在线动态监控淬火件温度的装置。

3·This paper introduces the design of taper bore flame hardening machine, fixtures, nozzles block and the methods to determine hardening temperature and phase balancing time.

介绍了内锥孔火焰淬火机床、工装和喷头的设计以及淬火加热温度和相平衡时间的确定方法。

4·As the hardening temperature increases, the speed hardening and degree of the adhesive JD increase, the mechanical and adhesion performances of the adhesive systems can be further improved.

而且随着固化温度的提高，胶粘剂体系的固化速度和固化程度还会进一步增加，力学性能、粘结性及耐热性能也会进一步提高。

5·In the conservation process, the control should be in favor of hardening concrete strength and growth temperature environments.

在养护过程中，应控制混凝土在有利于硬化及强度增长的温度环境中。

6·Hardening. This is the process of heating to a temperature above the critical range, and cooling rapidly enough through the critical range to appreciably harden the steel.

淬火。这个工艺是把材料加热到临界温度范围之上，然后迅速冷却到临界温度范围以下，使钢材明显变硬。

7·CONTROLLED COOLING: Process by which steel is cooled from an elevated temperature in a predetermined manner to avoid excessive hardening, cracking or internal damage.

强制冷却：将高温钢材强制冷却到设计温度的工序，可防止钢材硬化过度，破裂或者内部损伤。

8·B. Maintain rammed earth with minimal moisture loss at relatively constant temperature for period necessary for hydration of cement and hardening of rammed earth.

在相对稳定的温度下，确保夯实墙的最小湿度，以保证水泥的水化和夯实墙的硬化。

9·CYCLE time: Amount of time product spends in a furnace at specified temperature for the purpose of carburizing or hardening product.

周期：产品在炉中某特定温度下渗碳或硬化所需要的时间。

10·Temperature deformation and autogenous deformation are the two major forms of deformation of hardening concrete in early age.

温度变形和自生变形是硬化混凝土在初龄期两种最主要的变形。